The World of HO Open Framed Motors
By Michael W.P. Ball Open framed motors for the majority of Brass Steam Locomotives and many Diesels still are in use since post World War II. They were a main stay to power the locomotive. These motors were all produced in Japan except for the Pitman Motor which was produced in the United States. About thirty five years ago the industry began changing over to the Can Motor. The Can Motor was introduced in new locomotives to be sold to the hobbyist. It wasn’t until a few years later that the hobbyist could buy the Can Motor for personal use. Why the sudden change to the Can Motor? What reason for such a major overhaul? The following is a presentation of the reasons for those changes and the advantages as well. The open frame motor was a nightmare to keep running. There were several reasons for this. 1. The brushes and armature are exposed to the atmosphere. This allows dust particles which are charged to accumulate on the armature and adhere to the brushes. This alone can cause major problems electrically. It takes more power to turn the motor due to resistance and debris build up. That is it creates a resistance which bogs done the motor. 2. The accumulation of static charged particles deposited on the two brushes becomes an inhibitor to the rotation of the armature and grinds it down making the motor useless. These particles also can cause scaring on the armature which can make the motor useless. 3. The open frame motor requires lubrication at each end of the motor where the bearings are located. The manufacturers would place a pad around the motor shaft next to the bearings. Here is where you would lubricate the motor. The problem is that these pads would get old and shrink thus eliminating the lubrication process. 4. The best thing to do is tear down the motor and rebuild/replace the vital components except the armature. This can be a difficult process and very time consuming. It doesn’t mean the motor is going to run any better. Open frame motors when left standing for any length of time, accumulate debris and generally won’t run. The Can Motor eliminated all of these problems and is far more sensitive to electrical input than the open framed motor. It was almost impossible running an open frame motor at low speeds where the Can Motor is best suited operationally. The open frame motor is not really adaptable to the new DCC operations. This is the opposite for the Can Motor as it is suited for running of locomotives which have the DCC decoders on board. The Can Motors are smaller than the open frame motors which made it easier for the hobbyist to install the new motor. Joy Ball has been involved in the restoration and maintenance of a variety of Brass Model Locomotives. Through her years of expertise, Mrs. Ball has perfected the art of train restoration often spending countless hours preserving vintage Brass Locomotives to running condition of even the newest Brass Model Replicas. It should be noted that the above article was written by Joys husband Michael Ball. Receive her free newsletter at http://www.brasslocomotiveworks.com. Article Source: http://EzineArticles.com/?expert=Michael_W.P._Ball http://EzineArticles.com/?The-World-of-HO-Open-Framed-Motors&id=167983 money lenders in singapore personal loans coffs harbour instant approval no credit check loan is project payday a scam
